Carbolite Work Tube End Seals Manual do Utilizador

MS76 – 1.00

MS76 – 1.00 8 6.0 SPECIFICATIONS Carbolite reserves the right to change specifications without notice.  Maximum positive pressure – 140mbar (2p

9 MS76 – 1.00

Carbolite, Parsons Lane, Hope, Hope Valley, S33 6RB, England. Te

1 MS76 – 1.00 1.0 INTRODUCTION 1.1 Models covered by this manual This manual covers the Carbolite twin clamp end seal. Key changes over the ex

MS76 – 1.00 2 2.0 INSTALLATION 2.1 Unpacking & handling Care must be taken when unpacking the end seals to avoid damaging the silicone seal ma

3 MS76 – 1.00 Assembly ‘twin clamp’ end seal  Place clamp ring (1) & ‘O’ ring (2) over the work tube orientated as shown (‘O’ ring should si

MS76 – 1.00 4  Place seal (5)(orientation not important) on to the end of the boss as shown Then press the blank plate (6) in place. Depending on

5 MS76 – 1.00  Use clamp (7) to secure the blank plate to the boss as shown 7 1

MS76 – 1.00 6 3.2 Use of probes/thermocouple entry Any metal object used to probe into the furnace tube while the furnace is connected to the su

7 MS76 – 1.00 4.0 MAINTENANCE 4.1 General maintenance Preventive rather than reactive maintenance is to be preferred. The type and frequency dep